Media Converter In Cisco Packet Tracer Link ((top)) Jun 2026

Connect the devices as follows:

Observe the link lights on your Packet Tracer workspace. When you first connect the fiber cable, the port lights will change from red to amber as the Spanning Tree Protocol (STP) converges. Within 30 to 50 seconds, the lights will turn green, indicating a successful physical link layer connection. End-to-End Ping Test To prove that media conversion is occurring seamlessly:

The keyword "link" in your search is vital. A media converter is useless if the physical link doesn't come up. media converter in cisco packet tracer link

Connect your switch or PC to the port of the media converter. Connecting Fiber Side :

Set the IP address to 192.168.1.20 with a subnet mask of 255.255.255.0 . 2. Run a Ping Test Open the desktop of PC0 and click on the . Type ping 192.168.1.20 and press Enter. Connect the devices as follows: Observe the link

| Mistake | Symptom | Solution | | :--- | :--- | :--- | | | The link light on the media converter stays orange/red. | Delete the cable. Use Copper Straight-Thread for RJ45 and Fiber for the SFP side. | | Mismatched SFP types | Fiber link down. | On the switch’s physical tab, ensure the inserted SFP matches the media converter's fiber spec (e.g., LX vs SX). | | Forgetting no shutdown | Line protocol is down. | Manually type no shutdown on both switch interfaces connected to the converter. | | VLAN mismatch | Ping fails despite link lights green. | Ensure both switch interfaces (Fa0/1 on 2960 and Gi0/1 on 3560) are in the same VLAN or both in trunk mode. | | Distance limit ignored | Signal degradation (rare in PT but modeled). | Keep fiber links under 500m in the simulation for SX, and under 10km for LX. |

Before diving into Packet Tracer, it helps to understand why this process is necessary: End-to-End Ping Test To prove that media conversion

Select PT-SWITCH-NM-1CE . This is a FastEthernet copper port. Drag and drop it into Slot 1 .

Use (Shift+S) or Real-time Mode :